EXPERIMENTAL ANALYSIS OF HEAT CONDUCTION THROUGH HOLLOW BUILDING BLOCKS
Keywords:Cavities, Experimental, Heat Transfer, Hollow Blocks
Experimental investigation of heat transfer for solid and hollow concrete blocks with 2, and 3 evenly spaced cavities in them is explored to determine the most appropriate number of cavity in building blocks for effective energy consumption in building without compromising the strength of the blocks and building. The samples were tested based on their crushing strength and heat flow resistance. The results show that for the same block size, increasing the number of holes leads to a corresponding increase in the heat resistant value of the block without compromising it’s physical strength greatly.
C. Caruana and C. Yousif (2014) “Heat Transfer Characteristics of Locally Manufactured Hollow Concrete Blocks” Sustainable Energy 2014: The Ise Annual Conference.
Mohamed A. Antar*, Hasan Baig (2009) “Conjugate conduction-natural convection heat transfer in a hollow building block” Applied Thermal Engineering 29 pp.3716–3720.
Specification for clay bricks and blocks, full index to Nigerian industrial standards, NIS (2000)
Navaratnarajah, Sathiparan & K. N. Anusari, M & N. Samindika, N. (2014). Effect of Void Area on Hollow Cement Masonry Mechanical Performance. Arabian Journal for Science and Engineering. 39. 7569-7576.
Roberto Fioretti and Paolo Principi (2014) “Thermal Performance of Hollow Clay Brick with Low Emissivity Treatment in Surface Enclosures” coatings, a journal of coatings and surface engineering. 4, 715-731 DOI: https://doi.org/10.3390/coatings4040715
Rogers, G. F. C., & Mayhew, Y. R. (1992). Engineering Thermodynamics, Work and Heat Transfer (4th Edition). Longman Scientific and Technical.
ZHANG, Y., DU, K., HE, J., YANG, L., LI, Y., & LI, S. (2014). Impact factors analysis on the thermal performance of hollow block wall. Energ DOI: https://doi.org/10.1016/j.enbuild.2014.02.037
y and buildings, 75, 330-341.
Terry M. Tritt (2004) Thermal Conductivity: Theory, Properties, and Application, fourth ed.. Kluwer Academic/Plenum Publishers, New York, USA. pp 187-202.
How to Cite
License and Copyright Agreement
In submitting the manuscript to the journal, the authors certify that:
- They are authorized by their co-authors to enter into these arrangements.
- The work described has not been formally published before, except in the form of an abstract or as part of a published lecture, review, thesis, or overlay journal.
- That it is not under consideration for publication elsewhere.
- That its release has been approved by all the author(s) and by the responsible authorities – tacitly or explicitly – of the institutes where the work has been carried out.
- They secure the right to reproduce any material that has already been published or copyrighted elsewhere.
- They agree to the following license and copyright agreement.
Authors who publish with International Journal of Engineering Technologies and Management Research agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License (CC BY-SA 4.0) that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors can enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or edit it in a book), with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) before and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.
For More info, please visit CopyRight Section