TY - JOUR AU - Jasiński, Radosław PY - 2018/08/31 Y2 - 2024/03/29 TI - NUMERICAL ANALISIS OF THE STRAINS AND STRESS STATES REINFORCED CLAY BRICK MASONRY WALLS HORIZONTALLY SHEARED JF - International Journal of Engineering Technologies and Management Research JA - Int. J. Eng. Tech. Mgmt. Res. VL - 5 IS - 8 SE - Articles DO - 10.29121/ijetmr.v5.i8.2018.277 UR - https://www.granthaalayahpublication.org/ijetmr-ojms/ijetmr/article/view/03_IJETMR18_A05_422 SP - 20-37 AB - <p><strong><em>This paper presents the results: stress and strain of bed joints mortar, masonry units, reinforcement bars and mechanism of cracking of numerical simulations using ANSYS of reinforced brick wall in the horizontal shear. Willam-Warnke (WW-5) failure criterion for mortar and bricks and Huber-Mises-Hencky (HMH) plasticity surface for bed joints steel reinforcement (steel smooth bars and truss type reinforcement) has been used. Coulomb-Mohr (CM) criterion in the contact surfaces of mortar and bricks have been used in the interface elements. Numerical calculations showed satisfactory convergence of research in the patterns of cracking; and the load-strain relationship was similar to the results of research with regard only to the cracking time. Destructive force numerical models Hu,cal correspond to the forces observed at the first cracks in the walls Hu,mv. Reduction of transverse and longitudinal deformation of mortar bed joints have been reported in the immediate vicinity of the bars, and the reduction of the main stress of the bricks is reported in the case of the use reinforcement.</em> </strong></p> ER -