SIGNIFICANCE OF MARBLE AND PORTLAND CEMENT
The aim of this current study is both to avoid the environmental. In this way, we will help to protect the environment by consuming the waste marble dust obtained as a by- product of marble sawing and shaping processes in the factories those operating in our region. Stone industry is an important factor in worldwide economy. Despite this, a large amount of residues is produced in ornamental stone industry with different dimension and particle size. The increasing rate at which raw material are continuously transformed into industrial products results in waste generation. Consequently, recycling of industrial wastes and byproducts is becoming a crucial demand by the environmental laws in agreement with the concept of sustainable development. The present study was therefore planned to explore the possibility of usage of waste marble powder (WMP) as partial replacement of sand for production of concrete This research work is concerned with the experimental investigation on strength of concrete and optimum percentage of the partial replacement by replacing (OPC) cement via 0%, 10%, 12.5%, 15%, 17.5% and 20% of stone waste. Keeping all this view, the aim of the investigation is the behavior of concrete while replacing of waste with different proportions of stone waste in concrete by using tests like compression strength.
Prof. P.A. Shirule, Ataur Rahman, Rakesh D. Gupta, “PARTIAL REPLACEMENT OF CEMENT WITH MARBLE DUST POWDER”, International Journal of Advanced Engineering Research and Studies, VOL.1 June 2012, E-ISSN2249–8974
Ali Ergun (2011), “Effects of the usage of diatomite and waste marble powder as partial replacement of cement on the mechanical properties of concrete”, Construction and Building Materials, 25(2), pp 806812. DOI: https://doi.org/10.1016/j.conbuildmat.2010.07.002
Huseyin Yılmaz Aruntas , Metin Guru, Mustafa Dayı , Ilker Tekin, “Utilization of waste marble dust as an additive in cement production”, Materials and Design 31 (2010) 4039–4042 DOI: https://doi.org/10.1016/j.matdes.2010.03.036
Valeria Corinaldesi, Giacomo Moriconi, Tarun R. Naik, “Characterization of marble powder for its use in mortar and concrete”, Construction and Building Materials 24 (2010) 113–117 DOI: https://doi.org/10.1016/j.conbuildmat.2009.08.013
Ali A. Aliabdo, Abd Elmoaty M. Abd Elmoaty, Esraa M. Auda, “Re-use of waste marble dust in the production of cement and concrete”, Construction and Building Materials 50 (2014) 28–41 DOI: https://doi.org/10.1016/j.conbuildmat.2013.09.005
Prof. Veena G. Pathan, Prof. Md. Gulfam Pathan, “Feasibility and Need of use of Waste Marble Powder in Concrete Production”, e-ISSN: 2278-1684, p-ISSN: 2320-334X
Deborah .O.Olanrewaju, “EXPERIMENTAL STUDY ON THE PARTIAL REPLACEMENT OF CEMENT BY MARBLE DUST ON CONCRETE”
Indian Journal of Engineering, “Study on marble dust as partial replacement of cement in concrete”, VOL.4, NUMBER 9, JULY 2013
Baboo Rai, Khan Naushad H, Abhishek Kr, Tabin Rushad S, Duggal S.K, “Influence of Marble powder/granules in Concrete mix”, International Journal of Civil and Structural Engineering Volume 1, No 4, 2011. DOI: https://doi.org/10.5402/2012/469272
M. S. Shetty, “CONTRETE TECHNOLOGY”, 3rd Edition, S. Chand & Company Limited, Delhi, 1992.
“ENGINEERING MATERIALS” by RANGWALA.
Copyright (c) 2018 Arvind Dewangan, D.P. Gupta
This work is licensed under a Creative Commons Attribution 4.0 International License.
License and Copyright Agreement
In submitting the manuscript to the journal, the authors certify that:
- They are authorized by their co-authors to enter into these arrangements.
- The work described has not been formally published before, except in the form of an abstract or as part of a published lecture, review, thesis, or overlay journal.
- That it is not under consideration for publication elsewhere.
- That its release has been approved by all the author(s) and by the responsible authorities – tacitly or explicitly – of the institutes where the work has been carried out.
- They secure the right to reproduce any material that has already been published or copyrighted elsewhere.
- They agree to the following license and copyright agreement.
Authors who publish with International Journal of Engineering Technologies and Management Research agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License (CC BY-SA 4.0) that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors can enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or edit it in a book), with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) before and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.
For More info, please visit CopyRight Section